Connection Report; Changing The Primary Connection; Addressing Alarms To An Alarm Station; Fig. 3-22. Site Tab's Report Of Primary Connections - Honeywell rapid eye System Administrator Manual

Setting up a Connection to a Rapid Eye Unit

Connection Report

Fig. 3–22. Site Tab's Report of Primary Connections.
In Admin software, the site tab reports the primary connection to a Rapid Eye site. See figure
Connection codes
The codes used to identify the primary connection, are listed in table 3–4, in the "Site Tab's
Report" column.
Table 3–4 Automatic Connection Names for a Rapid Eye Site
Site Tab's Report
(n) IP address
(d) telephone number
(p) telephone number (n) IP address

Changing the Primary Connection

If many connections to a unit are setup:
Drag the most commonly used connection to the first position in the "Connections to the Site"
list, while Adding a Site, p. 23, or Updating a Site, p. 25.

Addressing Alarms to an Alarm Station

Flexibility in security
Prioritizing alarm stations is optional and applies only if many Rapid Eye alarm stations were
created by your organization's Multi SA.
Purpose: cascading and priority
Your Multi system can have one or many alarm stations. With many, cascading is automatic and
customizable. You can specify which alarm stations your Multi-Media units tries to reach first.
46
Automatic Name
[site name] -> Network
[site name] -> Dial-up
[site name] -> PPP
3–22
Connection
network
dial-up
dial-up to RAS