Programming A Ptz Dome; Configuring A Preset On A Ptz Camera; Figure 6-7 Ptz Dome With Or Without Auto-Focus - Honeywell Rapid Eye System Administration Manual

Programming a PTZ Dome

Configuring a Preset on a PTZ Camera

TIP!
Document 800-07769 Rev A
02/11
Figure 6-7 PTZ Dome with or without Auto-focus
Without Auto-focus option
PTZ Preset
Presets are set during a
Maintenance
preset when a Live session ends and the camera is no longer in use.
Auto-focus
View supports an auto-focus control when two dots appear in the – Focus + arc of the
PTZ controller. Click between the dots to toggle auto-focus on and off. See
Auto Iris
View supports an auto-iris control when two dots appear in the – Iris + arc of the PTZ
controller. Click between the dots to toggle auto-iris on and off.
1. Continue or start a
Maintenance
2. Click the Video tab. Select the PTZ camera from the list of cameras.
3. Click PTZ.
4. In the Preset Programming area, click the drop-down arrow (see
appears. By default, the list contains:
Preset 1, Preset 2, Preset 3 and so on (to 127, total)
Preset 1 may have already been set by an installer, to be used after a session is
closed. See
Behavior of PTZ After a Session Closes
installer or security officer before changing the first preset of a PTZ camera.
5. Click an item in the Preset Programming list.
6. If desired, you may rename the preset.
7. Set the camera pan, tilt and zoom values, as explained in
on page 97. You can also select continuous panning.
8. Click Save Preset. The camera pan position, tilt angle and zoom value are saved.
Rapid Eye DVR System Administrator Guide
With Auto-focus option. Click between
the dots to toggle Auto-focus On/Off.
Session. A PTZ camera can be set to return to the first
Session.
on page 101. Consult your site's
Using the Dartboard Control
Figure 6-7.
6-8). A list
Figure
99