Rapiddome Ptz Tours; Rapiddome Mimic Tour - Honeywell rapid eye System Administrator Manual

Preset tours. A "preset tour" recalls a list of PTZ presets. Before setting up a preset tour,
someone is needed to setup presets.
Privacy zones. Use presets 100 to 127. The video feed is not displayed when a dome is
positioned at these presets.
Fig. 6–10. Detail of PTZ Setup for the RapidDome Driver.
Detail of PTZ setup for the RapidDome Driver, on the Video tab, during a
Details show controls for the mimic tour (1), preset tour (2) and privacy zone (4). The selection of
presets and tours is made using the list (3) above the PTZ controller. In the list, "Vector" is used to
select a preset tour.

RapidDome PTZ Tours

1. In the PTZ controller, click the arrow in the box under the row of numbered button to display a list,
showing: "Preset, "Tour" and "Vector". See figure 6–10–(3), on page 95.
2. Do one of the following:
For mimic tours, select "Tour".
For preset tours, select "Vector".
3. Click a button in the row of numbered buttons, above the box that shows the list.

RapidDome Mimic Tour

1. While using View, select a site that has one or more RapidDome PTZ cameras.
2. Run a Maintenance
3. Select a dome camera.
Document 800-02325 Rev A
07/08
Session; click the Video tab.
System Administrator Guide
Maintenance Session.
95