Setting Lower Values For Continuous Recording; Event Recording On Demand, Using The Boost Button - Honeywell rapid eye System Administrator Manual

Enhancing Video for Security
Authorized Configuration
Event Recording can be configured by the Multi SA in your organization, or by other operators
who have the right to run a
Caution: Using high values for
the point of making it unusable. See
Automatic DSP Performance Maximization
A Multi SA can optimize
Performance, p. 72.
Multi-Media LT
On Multi-Media LT units, the maximum resolution for NTSC is 640×240; for PAL, 704×288; this is
lower than on Multi-Media DSP units.
Live Video
The settings for Continuous Recording and Event Recording are independent of those for live
video.

Setting Lower Values for Continuous Recording

The values for Continuous Recording need to be lower (or equal) to the values of Event
Recording . If higher values cannot be set for Event Recording, check if high values are used for
Continuous Recording.

Event Recording on Demand, Using the Boost Button

Once Event Recording is set, View software operators have the option of clicking the Boost
button, while monitoring Live video. See figure 7–2. For the location of the button, see the Remote
View Operator Guide, K14391.
Fig. 7–2.
Event Recording
In View software, the button for Event Recording is unavailable while a tour is running. To enable
the button, pause the tour first.
104
Maintenance
Continuous Recording
Using Higher Values When Recording
Event Recording
Boost Button.
on demand during a Site Tour
Session.
can shorten a unit's video archive to
settings. See Automatic Maximization of DSP
Video, p. 127.