Users; Key Facts - Honeywell rapid eye System Administrator Manual

Users

Key Facts

Flexibility
If one operator, or very few users are operating the Multi-Media unit(s) in your organization, you
may not need to create user accounts. See
many Rapid Eye operators or units, Honeywell recommends creating user accounts for unit
operators.
Account users operate Multi-Media units
It can be more accurate to refer to account users as "unit operators"; a Multi SA creates accounts
so that personnel can operate units. Accounts created using LocalView can be used only onsite at
the site that they were created. Accounts created using Admin are generally used to run View
software on a PC, to connect to one or many units, over a LAN or using dial-up.
Administrator account
To run Admin software, use the Administrator account. Use of Admin and the Administrator
account should be reserved for use by your organization's Multi SA. Reasons for doing so are
explained in
used to run View software, to configure units, by using a Maintenance Session.
System password
The system password is not used by users. Authorized users do not need to know and should not
know the system password. It protects units from Admin and View users in other organizations.
See System
Using LocalView only
Multi SAs have the option of creating user accounts onsite, using LocalView, on a unit-by-unit
basis. This is convenient when your organization has only one unit, or very few and few users.
See User
Document 800-02325 Rev A
07/08
Limiting the Use of Admin, on p. 168. The default Administrator account can also be
Password, p. 172.
Management, p. 157.
Default User, on p. 156. However, in organizations with
9
155