Installation
Connecting a PTZ Camera
Connecting to a Sensor Input
Connecting to a Relay Output
Installing the Rackmount Kit
______________________________________________________________________________________________
26
The RS485 connector can be used to control Pan / Tilt / Zoom (PTZ)
cameras. See the PTZ camera manufacturer's manual for configuring the
RS485 connection.
Note
Use the RS485 connector for external control systems such as a
control keyboard. Connect RX-/TX- and RX+/TX+ of the control
system to the TX-/RX- and TX+/RX+ (respectively) of the DVR.
To make connections on the Alarm Connector Strip: Press and hold the
button and insert the wire into the hole below the button. To disconnect the
wire press and hold the button above the wire and pull it out.
Alarm In
Use external devices to send a signal to the DVR when an event occurs.
Mechanical or electrical switches can be wired to the Alarm In and Ground
(GND) connectors.
Note
All connectors marked GND are common. Connect the ground
side of the alarm input and/or alarm output to the GND connector.
To make connections on the Alarm Connector Strip: Press and hold the
button and insert the wire into the hole below the button. To disconnect the
wire press and hold the button above the wire and pull it out.
Alarm Out
The DVR can activate external devices such as buzzers or lights. Connect
the external device to the Alarm Out and Ground (GND) connectors. See
Sensor Configuration in the manual for more details.
Caution There must be a minimum 1U space between the DVR and any
other items in the rack.
1.
Attach the rackmount brackets with the screws provided on each side
of the DVR. Do not remove the plastic edge guards.
2.
Mount the DVR in your rack.