System Password Extras - Honeywell rapid eye System Administrator Manual

4. Remove the asterisks in the Confirm Password box; the two boxes in the System Password
window should be empty; see fig. 10–4, above.
5. Click Save and Close.
6. Using View, start a
password. Either:
Right-click the site name (on the Site tab) to select Maintenance from the shortcut menu.
Select the site; click the Maintenance command on the Actions menu.
Select the site; then click
7. Click the Security tab in the Maintenance window.
8. Click Update security on the Security tab.
9. End the Maintenance Session; see
10. You have the option of powering down the Multi-Media unit and disconnecting it from your
network or its telephone line.
11. Run Admin to access the System Password window.
12. Type the system password used earlier in the System Password box (the password that was
removed in step 1 of this procedure).
13. Retype the password in the Confirm Password box.
14. Click Save and Close.
15. To follow-up:
The Multi SA may need to tell some users that they need to refresh their copy of the Multi db.
See Refreshing a Local
You have the option of deleting the site in the site list, as explained at
If the system password is not removed from a unit, that system password will need to be
remembered when you another site definition is created for that Multi-Media unit. The
system password is also needed if you delete a site definition by mistake. See
Site, p. 23, and

System Password Extras

Older system password
If you do not know the system password at a site, you will run into some difficulty using the
procedure "Remove on One of Many Units" in
2 on p. 175, shows that reports of "Yes; set." or "No; set." indicate that the system password on
the unit is not current.
If a unit reports "Yes; set." or "No; set.", run a
as explained in
System Password, Part 1 (of 3): Using
When there are many Multi-Media units in a Rapid Eye system
What you want to avoid when there are many Multi-Media units in your Rapid Eye system, is to
avoid changing the system password then updating security on only a few units. Doing so
Document 800-02325 Rev A
07/08
Maintenance Session for site(s) from which you want to remove the system
on the toolbar.
Ending
Database, on p. 250.
Deleting a Site, p.26.
Updating Security on a Multi-Media
Admin, on p. 174.
System Administrator Guide
Maintenance, p. 60.
Removing a System Password, on p. 175. Table 10–
Maintenance Session to update security on the unit,
Unit, on p. 133; or in part 3 of
Deleting a Site, on p. 26.
Adding a
Changing the
177