Testing A Preset Tour On A Rapiddome Camera - Honeywell rapid eye System Administrator Manual

4. Click PTZ. Check if the Driver is "RapidDome/Orbiter". If not, the remaining steps in this procedure
cannot be used. In the "Tour Programming" section, click Preset Tour (Vector). While a preset
tour is being programmed, the RapidDome dome does not move. You have the option of selecting
which of the four preset tours you plan to setup. To do so, click the arrow button above Dwell
Time. See figure
Click the name that you need.
5. To add a preset to the preset tour, right-click in the table in Tour Programming. A menu appears,
showing an Insert command, as in figure
6. Click the Insert command. A preset is added to the list.
Speed. You have the option of setting the time (in seconds) that the dome will take to reach the
preset, by clicking the cell in the Speed column, on the line of the preset. An arrow appears.
Click the arrow and select a value. Click the arrow and select a value, from "0" to "127". See
figure
Dwell. You have the option of setting the time (in seconds) during which the dome will stay in
the preset position, by clicking the cell in the Dwell column, on the line of the preset. An arrow
appears. Click the arrow and select a value, from "0" to "255".
Preset Name. You have the option of replacing the preset with another, by clicking the cell in
the Preset Name column, on the line of the preset. An arrow appears. Click the arrow and
select a value, from "1" to "127". Note: preset 100 to 127 can be designated as privacy zones.
7. Repeat step 6, above, as needed. While adding more presets, you also have the option of using
these commands:
Move Up/Down. You have the option of moving a preset up or down in the list, including its
Speed and Dwell times. Right-click in the # column, on the line of the preset; a menu appears.
Click Move Up or Move Down, as needed.
Delete. You have the option of deleting one preset or many from the list, by right-clicking in the
# column, on the line of the preset. On the menu that appears, click Delete. To select many
presets, press and hold the Ctrl key on the PC's keyboard while clicking on different lines in the
# column.
Test. You have the option of testing the preset tour by clicking Test. To stop the testing of a
preset tour, click End.
Rename tour. You have the option of renaming the preset tour. Click inside the box next to
Preset Tour (Vector). Type a name. The name is saved when you next click the mouse. See
figure 6–12, below: "Entrances" has replaced the default name of "Vector 1".
8. Click Program Vector to send the tour of presets to the camera. You have the option of
programming another tour of presets for the dome camera; repeat steps 5 to 7 as needed.
Fig. 6–12. Location of the Program Vector Button.

Testing a Preset Tour on a RapidDome Camera

1. While using View, select the site at which you have programmed a Preset Tour on a RapidDome
camera, as shown in procedure To Setup a Tour of Presets on a RapidDome Camera.
Document 800-02325 Rev A
07/08
6–11 (2). A list appears, showing "Vector 1, Vector 2, Vector 3 ..." by default.
6–11 (2).
6–11 (1).
System Administrator Guide
97