Privacy Zones For Rapiddome; To Set A Privacy Zone; Acuix Dome Camera - Honeywell rapid eye System Administrator Manual

Pan, Tilt, and Zoom (PTZ) Setup
2. Run a Maintenance
3. Select the dome camera that is programmed with a Preset Tour.
4. Click PTZ. Check if the Driver is "RapidDome/Orbiter". If not, the wrong camera or site may have
been selected in step 1 and the remaining steps in this procedure cannot be used.
5. In the "Tour Programming" section, click Preset Tour (Vector).
6. Select the preset tour that you plan to test. To do so, click the arrow button above Dwell Time. A
list appears, showing "Vector 1, Vector 2, Vector 3 ..." by default. Click the name that you need.
7. Click Test.

Privacy Zones for RapidDome

Fig. 6–13. Setting Up a Privacy Zone on a RapidDome PTZ Camera.
PTZ preset 100 to 127 can be toggled to not display or to display the video feed coming from the
RapidDome, when the dome is in the preset's angle and zoom.
Reset All. To cancel the privacy applied to presets, click Reset All. A confirmation dialog box
appears. Click Yes.

To Set a Privacy Zone

Select the box next to the preset name so that it shows a check-mark. See figure 6–13, above, and
figure 6–10–(4), on page 95. Remove the checkmark to enable Live and recoded video from that
PTZ preset.

ACUIX Dome Camera

An ACUIX™ PTZ dome camera with Intellibus™ can be used and configured using Rapid Eye
View software. In preparation, installers have:
Set each ACUIX dome camera to their Intellibus mode (IBus).
Set DIP switch 5–8 to ON, on each ACUIX dome camera. The Camera Address can then be
set using rotary switches (SW1 to SW4) on the PCB at the base of the dome.
Connected the ACUIX dome cameras to a port on the Rapid Eye unit.
Notified the Multi SA of the number of the port used on the Rapid Eye unit and the
Camera Address used for each ACUIX dome camera.
98
Session; click the Video tab.