To Test A Mimic Tour On A Rapiddome Camera; Rapiddome Preset Tour; To Setup A Tour Of Presets On A Rapiddome Camera - Honeywell rapid eye System Administrator Manual

Pan, Tilt, and Zoom (PTZ) Setup
4. Click PTZ. Check if the Driver is "RapidDome/Orbiter". If not, this procedure cannot be used. In the
"Tour Programming" section, the Mimic Tour is selected by default. See figure 6–10, above. You
have the option of selecting which of the four mimic tours you plan to setup. To do so, click the
arrow button above the End button. A list appears, showing "Tour 1, Tour 2, Tour 3 ..." by default.
Click an item in the list.
5. Click Program. A message appears below the buttons in the Tour Programming section: "Tour
Programming in progress ..." See figure 6–10, above.
6. Pan, tilt and zoom the camera, as needed.
7. Click End.
You have the option of testing the mimic tour by clicking Test.
You have the option of renaming the mimic tour. Click inside the box in the Tour Programming
section. Type a name. Save the name by clicking the mouse.
8. You have the option of programming another mimic tour for the dome camera; repeat steps 5 to 7
as needed.

To Test a Mimic Tour on a RapidDome Camera

1. While using View, select the site at which you have programmed a mimic tour on a RapidDome
camera, as shown in procedure RapidDome Mimic Tour.
2. Run a Maintenance
mimic tour.
3. Click PTZ. Check if the Driver is "RapidDome/Orbiter". If not, the wrong camera or site may have
been selected and this procedure cannot be used.
4. In the "Tour Programming" section, select a mimic tour, using the arrow button above the End
button. By default, they are named "Tour 1, Tour 2, Tour 3 ..."
5. Click Test.

RapidDome Preset Tour

Before setting up a preset tour, set some presets. See
Fig. 6–11. Right-clicking in the Tour Programming table reveals the Insert command.

To Setup a Tour of Presets on a RapidDome Camera

1. While using View, select a site that has RapidDome PTZ cameras.
2. Run a Maintenance
3. Select a dome camera.
96
Session; on the Video tab, select the dome camera that is programmed with a
Session; click the Video tab.
To Configure a Preset on a PTZ Camera, p. 91.