Ppp: Ip Settings Reserved For Modem Connection; To Set An External Modem; Table 8-3 Default Modem And Dial-Up Communications Settings; Table 8-4 Names Of Temporary Tcp/Ip Addresses, For Ppp - Honeywell rapid eye System Administrator Manual

Table 8–3 Default Modem and Dial-up Communications Settings
Device
Modem hardware
PPP temporary network

PPP: IP Settings Reserved for Modem Connection

During a dial-up connection, temporary network communications are established between the
Rapid Eye site and the PC. A Host IP address for the Multi-Media unit is auto-detected by the
Microsoft Dial-Up Networking application in Windows. Different terms are used to describe these
communication points; to avoid confusion, these terms are listed in table 8–4.
Table 8–4 Names of Temporary TCP/IP Addresses, for PPP
Address*
172.26.200.1
172.26.2.1
* This is not the Multi-Media unit's network address, discussed in
Session.
The default, point-to-point protocol (PPP) Internet Protocol (IP) settings can be changed, in the
unlikely event that they conflict with another network device (printer, scanner, and so on).

To Set an External Modem

1. Consult the installer to find out which port on the unit is connected to the modem.
2. Continue or start a
3. Click the Serial Devices tab.
4. Click the "Internal Port - Modem" icon. Boxes appear in the right half of the Serial Devices tab:
Baud Rate, Wait for connection and so on.
5. Change the values to those suggested by the external modem's documentation.
6. Drag the modem icon to the port icon bearing the number of the port identified in step 1.
Document 800-02325 Rev A
07/08
Box
Baud
Wait
Prefix
Initialization
Dialing
Client IP
Host IP
Internal Port Laymen's term
PPP: client IP at operator's PC
PPP: host IP* at Multi-Media unit
Maintenance Session for the Rapid Eye site.
System Administrator Guide
Value
115,200
60
AT
Z
D
172.26.200.1
172.26.2.1
Installation shell
host
local
System Tab in a Maintenance
141