Table of Contents
Advertisement
MSD-501/502/701/702 User's Guide
Press the "MENU/SET" key to perform automatic measurement.
●Can be measured:
Input video contacts the circumscribed rectangle.
Brightness of input video is 25% or more.
Input video
Valid display
area
Note:
In case the aspect ratio does not match or video is displayed on the position far from the correct position, set
the input timing in "7.7.2 The total number of horizontal dots", "7.7.3 Start position", and "7.7.4 Active area".
■ Operation from input channel selection key
You can execute the automatic measurement not only from this menu but also by pressing an input selection
key for 2 seconds or longer. By pressing an input selection key for 2 seconds, the auto measurement mode
with "NORMAL MODE" will be enabled. After that, pressing the same key for 3 seconds or longer, the auto
measurement mode with "NEXT ASPECT" will be enabled. (This auto measurement mode can be enabled
also by pressing the input key for 5 seconds or longer continuously.) Once you perform the function, from the
next time, it can be performed simply by pressing the key without pressing it for several seconds. This mode
can be canceled 5 seconds after the last auto measurement is executed.
・MSD-501 / 502: IN4 or IN5 key
・MSD-701 / 702: IN5, IN6, or IN7 key (IN5 is for analog)
Pressing and holding the
key
[Fig. 7.10] Automatic measurement using input channel selection key
46
●Cannot be measured:
Right and left sides of input video do not touch the circumscribed
Brightness of input video is 24% or less.
Input video
[Fig. 7.9] Conditions of automatic measurement
2 sec.
2 sec.
Automatic measurement starts
(NORMAL MODE)
5 sec.
2 sec.
rectangle.
Input video
5 sec.
7 sec.
Automatic measurement starts
(NEXT ASPECT)
Terminates if no operation is
performed for 5 seconds
Automatic measurement starts if you press the
key within 5 seconds.
Advertisement
Table of Contents
