Table of Contents
Advertisement
7.9.5 Lip sync
Menu
Top→AUDIO→OUTPUT LIP SYNC (Output side) / INPUT LIP SYNC (Input side)
Setting for
Output side
Input side
Setting value 0FRAME to 8FRAME [Default]: 0FRAME
You can adjust the gap between video (motion) and audio (sound).
Up to eight frames can be set for each input/output channel.
7.9.6 Sampling frequency
Menu
Top→AUDIO→SAMPLING FREQUENCY
Setting for
Each output (COMMON TO OUTA AND OUTB)
Setting value
・AUTO-A [Default]
・AUTO-B
You can set the sampling frequency of digital audio output.
■If you select "AUTO-A" or "AUTO-B":
"AUTO-A": outputs digital audio with the maximum sampling frequency supported by the connected sink
device to OUTA output connector.
"AUTO-B": outputs digital audio with the maximum sampling frequency supported by the connected sink
device to OUTB output connector.
At this time, the sampling frequency that is actually output is displayed in parentheses. In case EDID cannot
be loaded from the sink device, the sampling frequency that was used the last time is selected with "*" on its
right side.
[Fig. 7.11] Left: maximum sampling frequency; right: sampling frequency used last time
: Each output (COMMON TO OUTA AND OUTB)
: Each input/input signal
・32kHz
・48kHz
・44.1kHz
・88.2kHz
[OUT1 FREQUENCY]
AUTO-A(48kHz)
MSD-501/502/701/702 User's Guide
・96kHz
・192kHz
[OUT1 FREQUENCY]
AUTO-A(48kHz)*
57
Advertisement
Table of Contents
