Table of Contents
Advertisement
Setting
Item
COM
RECV
yes
DISPLAY
*1
DELIMITER
yes
*2
RCV CHECK
yes
*3 *4
TIME OUT
yes
*3 *4
RETRY
yes
*3 *4
INTERVAL
yes
*3 *4
ERROR
yes
HDMI CEC
no
*7
control
Process for
no
CEC error
MEMO
yes
If you set "RECV DISPLAY" to "OFF", you cannot set this item.
*1
If you set "RECV DISPLAY" to "ASCII" or "HEX", you cannot set this item.
*2
If you set only "LOOP BACK" of communication ports to "ON", you do not need to set this item.
*3
If you set all "RCV CHECK" to "NOT CHECK", you do not need to set this item.
*4
If you set "RS:RS-232C" to "ON", set "7.11.2 Operation mode" to "TRANSMITTER".
*5
If you set any LAN connections for "LAN1" to "LAN8" to "ON", set "7.12.2 Operation mode" to
*6
"TRANSMITTER".
*7
CEC: only power ON/OFF of the sink device can be controlled.
[Table 7.12] Setting value of control command
CEC
Set whether received data is displayed or
no
not.
no
Set the delimiter to be sent at the end of
the received data.
"NONE": delimiter is not checked and all
received data within the set timeout will be
valid.
Value other than "NONE": delimiter is
checked and data received before
delimiter will be valid.
no
Set whether reply command that may be
returned is checked or not.
no
Set the timeout time for reply command to
a sent command.
Set the number of retries to resend the
no
same command again if no valid response
is replied.
no
Set the retry interval to resend the
command.
Set whether the next command is to be
no
executed or not if no valid response is
replied, even after completing retry for the
set number of retries.
Set the CEC control for the sink devices
yes
connected to OUT1A / OUT2A / OUT1B /
OUT2B.
Set whether the next command is executed
yes
or not if no response is replied from the
sink device that is controlled with CEC.
Register a note up to 14 characters.
yes
The registered note is displayed when the
control command is executed.
MSD-501/502/701/702 User's Guide
Description
Range
OFF [Default]
ASCII
HEX
NONE [Default]
00 to FF (Hex)
CHECK
NOT CHECK [Default]
0ms to 99s999ms
[Default]: 0ms
0 to 99 (times)
[Default]: 0
0ms to 99s999ms
[Default] 0ms
STOP [Default]
EXEC: continue
-: not control [Default]
POWER OFF
POWER ON
STOP [Default]
EXEC: continue
20 to 7D in ASCII codes except
for 2C (,)
[Default] 20 (space)
75
Advertisement
Table of Contents
