Ricoh D065 Service Manual page 784

5803 Input Check
Description
0
019 LD-0 Iop Monitor
020 LD-1 Iop Monitor
021 LD-2 Iop Monitor
022 LD-3 Iop Monitor
023 Capacitor Port 1
024 Capacitor Port 5
025 Capacitor Port 7
200 Scanner HP Sensor
201 Platen Cover Sensor
202 Scanner fan lock signal
4.2.2 COPIER OUTPUT CHECK: SP5804
Motors keep turning in this mode regardless of upper or lower limit sensor signals.
To prevent mechanical or electrical damage, do not keep an electrical component
on for a long time.
1. Open SP mode 5804.
2. Select the SP number that corresponds to the component you wish to check. (Refer to
the table on the next page.)
3. Press On then press Off to test the selected item.
You cannot exit and close this display until you press off to switch off the output
check currently executing. Do not keep an electrical component switched on for a
long time.
SM Appendix
Reading
1
[0 to 99.5 / - / 0.5 mA]
[0 to 99.5 / - / 0.5 mA]
[0 to 99.5 / - / 0.5 mA]
[0 to 99.5 / - / 0.5 mA]
Japan only
HP
Close
Rotation
4-251
Input/Output Check
Not HP
Open
Locked
D062/D063/D065/D066