Ricoh D065 Service Manual page 1085

Bit Switches - 1
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
No Function
Addition of image data from
confidential transmissions on
0
the transmission result report
0: Disabled 1: Enabled
Inclusion of communications on
the Journal when no image data
1
was exchanged.
0: Disabled 1: Enabled
Automatic error report printout
2
0: Disabled 1: Enabled
Printing of the error code on the
3 error report
0: No 1: Yes
4 Not used
Power failure report
5
0: Disabled 1: Enabled
Conditions for printing the
6 protocol dump list
0: Print for all communications
D418
System Switch 09 (SP No. 1-101-010)
If this feature is enabled, the top half of the first
page of confidential messages will be printed
on transmission result reports.
0: Communications that reached phase C
(message tx/rx) of the T.30 protocol are listed
on the Journal.
1: Communications that reached phase A (call
setup) of T.30 protocol are listed on the
Journal. This will include telephone calls.
0: Error reports will not be printed.
1: Error reports will be printed automatically
after failed communications.
1: Error codes are printed on the error reports.
Do not change this setting.
1: A power failure report will be automatically
printed after the power is switched on if a fax
message disappeared from the memory when
the power was turned off last.
This switch becomes effective only when
system switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a
72
Comments
SM