Ricoh D065 Service Manual page 1132

No Function
0: Disabled
1: Enabled
5 Not used
Parameter selection for the dial tone
detection
6
0: Normal parameter
1: Specific parameter
7 Not used
G3 Switch 08 - Not used (do not change the settings)
G3 Switch 09 - Not used (do not change the settings)
No Function
Maximum allowable carrier drop
0-1
during image data reception
Bit 1 Bit 0
0 0
0 1
1 0
SM
G3 Switch 07 (SP No. 1-105-008)
Do not change the settings.
0: This uses a fixed table in ROM for the
dial tone detection.
1: This uses a SRAM value that can be
adjusted for the dial tone detection.
Select this if the dial tone cannot be
detected when "Normal parameter: 0" is
selected.
Do not change the settings.
G3 Switch 0A (SP No. 1-105-011)
These bits set the acceptable modem
carrier drop time.
Try a longer setting if error code 0-22 is
Value (ms)
frequent.
200
400
800
119
Bit Switches - 4
Comments
Comments
D418