Ricoh D065 Service Manual page 683

Service Program Mode Tables
Adjusts the roller timing at the interval sensor/scanning roller. A higher setting
causes more buckling.
[3 to -2/0/0.1 mm]
ADF Trailing Edge Erase Margin (Front)
007 These settings adjust the erase margin for the trailing edges for the front.
[–5 to +5/-1/0.1 mm]
ADF Trailing Edge Erase Margin (Back)
008 These settings adjust the erase margin for the trailing edges for the back.
[–5 to +5/-1/0.1 mm]
ADF Input Check
6007
See "p.4-255 "ADF Input Check: SP6007"" in the "Input/Output Check" section.
ADF Output Check
6008
See "p.4-256 "ADF Output Check: SP6008"" in the "Input/Output Check" section.
DF Free Run
6009
Performs an ADF free run in duplex original mode.
Stamp Position Adj.
6010
Adjust the position of "Finished" stamp.
[-5 to 5 / 0 / 0.1 mm]
⇒
Original Size Determination Priority (
6016
Allows selection of alternate settings for automatic original size detection.
[0 to 255/0/1] (
6017 Sheet Through Magnification
D062/D063/D065/D066
4.2.11 SP6016: Original Size Determination Priority
4-150
4.2.11 For more information)
Rev. 03/11/2010
SM Appendix