Ricoh D065 Service Manual page 1127

Bit Switches - 4
No Function
received
1: After four PPR signals
received (ITU-T standard)
Modem rate used for the next
page after receiving a negative
5
code (RTN or PIN)
0: No change 1: Fallback
6 Not used
Select detection of reverse
polarity in ringing
7
0: Off
1: On
No Function
Training error detection
0-3
threshold
D418
G3 Switch 03 (SP No. 1-105-004)
modem rate after receiving a PPR, if the following
condition is met in communications at 14.4, 12.0,
9.6, and 7.2 kbps.
NTransmit- Number of transmitted frames
NResend- Number of frames to be retransmitted
1: When using ECM, the machine sends a CTC to
drop back the modem rate after receiving four
PPRs.
PPR, CTC: These are ECM protocol signals.
This bit is not effective in V.34 communications.
1: The machine's tx modem rate will fall back
before sending the next page if a negative code is
received. This bit is ignored if ECM is being used.
Do not change the settings
This switch is used to prevent reverse polarity in
ringing on the phone line (applied to PSTN-G3
ringing). Do not change this setting
0: No detection (Outside Japan)
1: Detection (Inside Japan only)
G3 Switch 04 (SP No. 1-105-005)
0 - F (Hex); 0 - 15 bits
If the number of error bits in the received TCF is
below this threshold, the machine informs the
114
Comments
Comments
SM