Ricoh D065 Service Manual page 1056

Rev. 10/05/2009
Code
Memory overflow while
22-01
receiving
Tx or rx job stalled due to
22-02 line disconnection at the
other end
The machine cannot
22-04 store received data in the
SAF
No G3 parameter
22-05
confirmation answer
Data read timeout during
23-00
construction
The machine software
25-00
resets itself after a fatal
transmission error
occurred
⇒
31-21 LAN Fax Error
F0-xx V.34 modem error
F6-xx SG3-V34 modem error
SM
Meaning
Add optional page memory.
Wait for the files in the queue to be sent.
Delete unnecessary files from memory.
Transfer the substitute reception files to
another fax machine, if the machine's printer is
busy or out of order.
Add an optional SAF memory card or hard
disk.
The job started normally but did not finish
normally; data may or may not have been
received fully.
Restart the machine.
Update the ROM
Replace the FCU.
Defective FCU board or firmware.
Restart the machine.
Replace the FCU
Update the ROM
Replace the FCU.
• It was cancelled received LAN Fax images
during store the image to SAF of FCU.
• The LAN Fax transmission of a message was
cancelled by the LAN Fax driver.
Replace the FCU.
Update the SG3-V34 modem ROM.
Replace the SG3-V34 board.
Check for line noise or other line problems.
Try communicating another V.8/V.34 fax.
Suggested Cause/Action
43
Error Codes
D418