Ricoh D065 Service Manual page 1039

Error Codes
Code Meaning
The other end sent RTN
or PIN after receiving a
0-08
page, because there
were too many errors
Non-standard post
0-14 message response code
received
The other terminal is not
0-15 capable of specific
functions.
CFR or FTT not detected
0-16
after modem training in
D418
Suggested Cause/Action
Check the line connection.
Check the FCU - NCU connectors.
Replace the NCU or FCU.
The other end may have jammed, or run out of
paper or memory space.
Try adjusting the tx level and/or cable
equalizer settings.
The other end may have a defective
modem/NCU/FCU; try sending to another
machine.
Check for line problems and noise.
Cross reference
Tx level - NCU Parameter 01 (PSTN)
Cable equalizer - G3 Switch 07 (PSTN)
Dedicated Tx parameters - Section 4
Check the FCU - NCU connectors.
Incompatible or defective remote terminal; try
sending to another machine.
Noisy line: resend.
Try adjusting the tx level and/or cable
equalizer settings.
Replace the NCU or FCU.
Cross reference
See error code 0-08.
The other terminal is not capable of accepting
the following functions, or the other terminal's
memory is full.
Confidential rx
Transfer function
SEP/SUB/PWD/SID
Check the line connection.
Check the FCU - NCU connectors.
26 SM