Ricoh D065 Service Manual page 1038

Code Meaning
Unsuccessful after
0-05 modem training at 2400
bps
The other terminal did
0-06
not reply to DCS
No post-message
response from the other
0-07
end after a page was
sent
SM
Suggested Cause/Action
Cross reference
Tx level - NCU Parameter 01 (PSTN)
Cable equalizer - G3 Switch 07 (PSTN)
Dedicated Tx parameters - Section 4
Check the line connection.
Check the NCU - FCU connectors.
Try adjusting the tx level and/or cable
equalizer.
Replace the FCU or NCU.
Check for line problems.
Cross reference
See error code 0-04.
Check the line connection.
Check the FCU - NCU connectors.
Try adjusting the tx level and/or cable
equalizer settings.
Replace the NCU or FCU.
The other end may be defective or
incompatible; try sending to another machine.
Check for line problems.
Cross reference
See error code 0-04.
Check the line connection.
Check the FCU - NCU connectors.
Replace the NCU or FCU.
The other end may have jammed or run out of
paper.
The other end user may have disconnected
the call.
Check for a bad line.
The other end may be defective; try sending to
another machine.
25
Error Codes
D418