Ricoh D065 Service Manual page 1119

Bit Switches - 3
No Function
same destination
Communication Switch 13 – Not used (do not change the settings.)
No
Inch-to-mm conversion during
0 transmission
0: Disabled, 1: Enabled
1-5 Not used
Available unit of resolution in which fax
6-7
messages are received
Bit 7 Bit 6
0 0
0 1
1 0
D418
Communication Switch 12 (SP No. 1-104-019)
Communication Switch 14 (SP No. 1-104-021)
Function
Unit
mm
inch
mm and inch
Comments
Comments
0: In immediate transmission, data
scanned in inch format are transmitted
without conversion.
In memory transmission, data stored in
the SAF memory in mm format are
transmitted without conversion.
Note: When storing the scanned data
into SAF memory, the fax unit always
converts the data into mm format.
1: The machine converts the scanned
data or stored data in the SAF memory
to the format which was specified in the
set-up protocol (DIS/NSF) before
transmission.
Do not change the factory settings.
For the best performance, do not change
the factory settings.
The setting determined by these bits is
informed to the transmitting terminal in
the pre-message protocol exchange (in
the DIS/NSF frames).
106 SM