Ricoh D065 Service Manual page 1133

Bit Switches - 4
No
1 1
Select cancellation of high-speed RX
if carrier signal lost while receiving
2
0: Off
1: On
3 Not used
Maximum allowable frame interval
4 during image data reception.
0: 5 s 1: 13 s
5 Not used
Reconstruction time for the first line in
6 receive mode
0: 6 s 1: 12 s
7 Not used
G3 Switch 0B Not used (do not change the settings).
G3 Switch 0C Not used (do not change the settings).
D418
G3 Switch 0A (SP No. 1-105-011)
Function
Not used
Comments
This switch setting determines if
high-speed receiving ends if the carrier
signal is lost when receiving during
non-ECM mode
Do not change the settings
This bit set the maximum interval
between EOL (end-of-line) signals and
the maximum interval between ECM
frames from the other end.
Try using a longer setting if error code
0-21 is frequent.
Do not change the settings.
When the sending terminal is controlled
by a computer, there may be a delay in
receiving page data after the local
machine accepts set-up data and sends
CFR. This is outside the T.30
recommendation. But, if this delay
occurs, set this bit to 1 to give the
sending machine more time to send data.
Refer to error code 0-20.
ITU-T T.30 recommendation: The first line
should come within 5 s of CFR.
Do not change the settings.
120 SM