Ricoh D065 Service Manual page 1125

Bit Switches - 4
No
1:On
7 Not used
No Function
0 Not used
1-3 Not used
DIS frame length
4
0: 10 bytes 1: 4 bytes
5 Not used
Forbid CED/AMsam output
6 0: Off
1: On (Forbid output)
7 Not used
No Function
G3 protocol mode used
0 0: Standard and non-standard
1: Standard only
1-4 Not used
D418
G3 Switch 00 (SP No. 1-105-001)
Function
G3 Switch 01 (SP No. 1-105-002)
Do not change the settings.
Do not change the settings.
1: The bytes in the DIS frame after the 4th byte
will not be transmitted (set to 1 if there are
communication problems with PC-based faxes
which cannot receive the extended DIS frames).
Do not change the setting.
Do not change this setting (Default: 0: Off),
unless communication problem is caused by a
CED or ANSam transmission.
Do not change the setting.
G3 Switch 02 (SP No. 1-105-003)
Change this bit to 1 only when the other end can
only communicate with machines that send
T.30-standard frames only.
1: Disables NSF/NSS signals (these are used in
non-standard mode communication)
Do not change the settings.
Comments
Do not change the settings.
Comments
Comments
112 SM