Table of Contents
Advertisement
When changing the frame rate option, the option is applied to the next test pattern you select
unless it is not available for that pattern. If a selected frame rate is not available, the default
frame rate is applied for the test pattern display.
Aligning the boresight
The boresight adjustment balances the tilt of the lens mount to compensate for screen-to-projector
tilt.
Caution! If not avoided, the following could result in minor or moderate injury.
•
Do not look directly into the lens when the light source is on. The extremely high brightness can
cause permanent eye damage.
1. Display the boresight test pattern.
a) In the right toolbar, select Test Patterns.
b) Select the RGB-2K-Boresight pattern and display it full screen.
2. Focus the image on cross-hair image I.
3. Evaluate the focus on cross-hair image II and III.
•
If all three images are in focus, no further action is required.
•
If boresight is required, continue to step 4.
The adjustment screws (A) on the lens mount affects the corresponding cross-hairs on the test
pattern.
Cinema 2K-RBe Installation and Setup Guide–CP2406-RBe, CP2409-RBe, and CP2411-RBe
020-103907-01 Rev. 1 (03-2024)
Copyright
©
2024 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Adjusting the image
51
Advertisement
Table of Contents
