Aligning Dual Projector Images - Christie CP2208 Installation And Setup Manual

Aligning dual projector images

1. Stack the projectors. For more information see the CP2208 User Manual (P/N: 020-101916-
XX).
2. On the bottom projector, adjust the image to fit the screen. See
screen on page
3. On both projectors, turn the lamp on and open the douser. See
23.
4. On the top projector, display a RGB-12bit-Full Screen White test pattern and center the image:
a. Tap the Test Pattern (
b. Tap All Test Patterns.
c. Tap RGB-12bit-Full Screen White.
d. On the projector touch panel controller (TPC), tap the Lens Adjust (
main screen and then tap the left (
in the Offset area until the light created by the projector is centered on the screen.
5. On the top projector, display the DC2K Framing Green test pattern. For more information see
the CP2208 User Manual (P/N: 020-101916-XX).
6. On the bottom projector, display the DC2K Framing Red test pattern. See pattern. For more
information see the CP2208 User Manual (P/N: 020-101916-XX).
7. Align the top projector image horizontally to the bottom projector:
a. On the top projector, remove the locking brackets from the projector feet.
b. Move the front or the rear of the top projector to the right or left so the projected image
is aligned horizontally with the image of the bottom projector.
8. Align the top and bottom projector images vertically:
CP2208 Installation and Setup Guide
020-102031-01 Rev. 1 (09-2015)
25.
) icon in the task bar.
Adjusting the image to fit the
Turning the lamp on
), right ( ), up ( ), or down (
on page
) icon on the
) arrow icons
26