Installing The Touch Panel - Christie CP4440-RGB Installation And Setup Manual

5. Fully insert the lens into the lens mount opening without turning, until it reaches the stop
position.
6. Connect the lens zoom motor to the two zoom motor harness connectors.
7. Lock the lens assembly in place by rotating the lens clamp downward.

Installing the touch panel

The touch panel controls projector functions and provides quick access to projector information.
The touch panel can be mounted on the rear panel or either side of the projector.
1. Remove the touch panel and the mounting arm from their packaging.
2. Attach one end of the touch panel mounting arm over the ball joint on the rear of the touch
panel.
CP4440-RGB and CP4450-RGB Installation and Setup Guide
020-103072-05 Rev. 1 (01-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
32