Installing And Setting Up; Site Requirements - Christie CP2420-Xe Installation And Setup Manual

Installing and setting up

Learn how to position and install the projector.

Site requirements

To safely install and operate the CP2420-Xe/CP4420-Xe projectors, the installation location must meet
these minimum requirements.
Physical operating environment
• Ambient temperature (operating) 10 to 35°C (50 to 95°F)
• Humidity (non-condensing) 10% to 80%
• Operating altitude 0 to 3000 meters (0 to 9843 feet)
External exhaust ducting
The installation site must provide sufficient external exhaust airflow to ensure adequate cooling of the
Xenon arc lamp.
• At 25°C (77°F) ambient or less and below 915 meters (3,000 feet), a minimum of 450 CFM is
required.
• Above 25°C (77°F) or above 915 meters (3,000 feet), a minimum of 600 CFM is required.
Permanent power connection
The projector must be connected to power using a hard-wired connection. The projector light source
(main input) requires the permanent AC connection to operate. There is also an available connector
for an uninterruptible power supply (UPS) to provide backup power for the projector electronics only.
Certified wall breakers are required as part of the installation. Breakers must be part of the building
and easily accessible. The size of the breaker is determined from the power requirements of the
projector and can be up to 30A maximum for the main input and up to 5A maximum for the UPS
input.
For the CP2420-Xe, a 30-32A double-pole, UL-listed wall circuit breaker with minimum 3 mm (.12
inches) contact gap is required.
CP2420-Xe and CP4420-Xe Installation and Setup Guide
020-103555-01 Rev. 1 (03-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
17