Table of Contents
Advertisement
Installing and setting up
Learn how to position and install the projector.
Site requirements
To safely install and operate the CP4415-RGB and CP4420-RGB Gen2, the installation location must
meet these minimum requirements.
Physical operating environment
•
Ambient temperature (operating) 10 to 35°C (50 to 95°F)
•
Humidity (non-condensing) 10% to 80%
•
Operating altitude 0 to 3000 meters (0 to 9843 feet)
External exhaust ducting
Sufficient ventilation is required around the projector to regulate the temperature of the internal laser
module. If necessary, air intake and exhaust HVAC ducts can be installed.
An exhaust duct is also available for purchase as an optional accessory (P/N: 163-102104-XX).
Instructions for installing the exhaust duct are included with the accessory part.
The installation site must provide an airflow 450 cubic feet per minute (CFM) at 1 to 1000 meters
(3280.8 feet) elevation, and must accommodate a heat load of 4 kW.
For each additional 1000 meters above sea level, increase the airflow (CFM) value by 15%. If an
extraction duct is not used, the operating temperature range is restricted to 10 to 25°C (50 to 77°F) at a
maximum altitude of 3000 meters (9842.5 feet).
Power specifications
Learn the power requirements for the projector.
Item
Main input
Rated voltage
Rated current
Line frequency
UPS input
Rated voltage
Rated current
Line frequency
CP4415-RGB and CP4420-RGB Gen2 Installation and Setup Guide
020-103773-01 Rev. 1 (02-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
CP4415 Gen2
200-240 VAC
11A, 1Φ
50/60 Hz
100-240 VAC
7A, 1Φ
50/60 Hz
CP4420 Gen2
200-240 VAC
13A, 1Φ
50/60 Hz
100-240 VAC
7A, 1Φ
50/60 Hz
20
Advertisement
Table of Contents
