Co Busy Tone Detection - Panasonic DBS 824 Manual

FF2

CO Busy Tone Detection

Software Version CPC-S and CPC-M, Version 1 0 and higher
Address FF2 (Trunk)# 22# (0 or l)#
Description
This address determines whether the DBS 824 system will look for a busy
tone from the CO for outgoing calls, for the purpose of activating the Auto-
Repeat Dial feature
When this programming address is set to "on' the DBS 824 will monitor
trunks for busy tone signals from the CO after outgoing calls are placed if the
busy tone occurs, the DBS 824 will automatically send a hookflash signal to
the CO and redial the number while the caller remains off-hook
Programming
Related Programming
Auto-Repeat Dialing Count FFl 2# l# 34# (O-15)++
Wait Time for Auto-Repeat Dialing FFl 3# 26# (O-15)++
Busy Tone @T) Detection Timer FFl 3# 27# (0-15)#
Dial Tone (D'I') Detection Timer FFl 3# 28# (0-255)#
Termination of the Auto-Repeat Dialing Feature The DBS 824 will
Notes
terminate the Auto-Repeat Dialing operation if one of the following occurs
Issued 3/l 195
FF2 (l-6 or l-8)# 22# (0
Trunk Number
CPC-S l-6
CPC-M l-8
Voice (or anything other than BT detection or time-out of the Auto-
Repeat Dialing Wait Time) is detected on the called-party end of
the outgoing call
Caller goes on-hook
l
.
RLS key is pressed
.
The trunk line is seized by another operation (e g , CO key or MC0
.
Other FF keys are pressed
DBS 824-i O-400
CO Busy Tone Detection
or
O=BT detection off
2-19