Panasonic DBS 824 Manual page 431

FF8
Time Priority Route Tables
Software Version - CPCS and CPC-M, Version 1 0 and higher
Address FF8 5# (l-6)## (l-24)# (114)#
Description
When LCR is used, outbound calls are automatically placed on different trunk
groups depending on the time of day The Time Priority Route Tables
determine which trunks are used during certain times of day Characteristics
of Time priority Route Tables are
l
l
Table 8-4 LCR time periods and positions used
l
Issued 3/l /95
Table Number Time
priority Route Tables are identified by numbers l-6
In DBS 824 programming, the tables are referred to by number
Table Position and Priority
of day during which it is used For example, a table assigned to
position "1" is used between 7 00 a m and 7 59 am Similarly,
a table assigned to position "9" is used between 5 00 pm and
7 59 pm LCR provides up to 24 positions for Time Priority
Route Tables
The 24 positions are divided among 6 time periods, each time period
uses 4 trunk groups For example, trunk groups assigned to positions l-
are used between 7 00 am and 7 59 a m The time periods and
4
positions used are described in the following table
Time Period
700a.m -759am
500pm -759pm
1 2 0 0 a m - 6 5 9 a m 1
position For example, between 8 00 am and 4 59 pm, position 5
has the highest priority, while position 8 has the lowest priority
The most cost-effective Time Priority Route Tables are assigned
positions that give them the highest priority LCR tries to use
the trunks in the highest-priority position first.
Each Time Priority Route Table is assigned to an LCR
trunk group Because the Time priority Route Table is assigned to a time of
DBS 824-l O-400
Time Priority Route Tables
Positions Used
l-4
5-8
9-12
13-16
17-20
21-24
I
I
I
8-11