Panasonic DBS 824 Manual page 455

Appendix B
Resuming SMDR or Bus Monitor Mode After Terminal Programming
The DBS 824's Serial Interface Unit (SIU) supports three remote functions
Bus Monitor
l
l
Terminal (Remote) Programming
l
However, only one of these functions can operate at a time When not in
Terminal (Remote) Programming, either SMDR or Bus Monitor is active
When you enter Terminal Programming (#99xXxX), the other function stops
When finished, the SMDR or Bus Monitor function resumes The DBS 824
can be reset to the desired SMDR or Bus Monitor mode by entering (or
having someone at the site enter) one of the following codes at an extension
or attendant position
Table B-2 Codes for switching SMDRJBus Monitor modes
Command Function
Issued 3/l /95
SMDR
Normal Bus Monitor on SJU Maintenance Port (CN2)
Register Bus Monitor on SIU Maintenance Port (CN2)
Poll Bus Monitor on SIU Maintenance Port (CN2)
DBS 824-l O-400
Terminal Programming
B-3