Panasonic DBS 824 Manual page 453

Appendix B. Terminal Programming
The body of this Section 400 is devoted to programming the DBS 824 system
through a key phone However, the DBS 824 can also be programmed
remotely via the Terminal Programming mode Using this method,
commands can be entered on
via modem or a local PC or terminal can be connected directly to the DBS
824's Maintenance port (CN2) on the Serial Interface Unit
You can enter the Terminal Programming mode using any of the following
three methods
l
l
l
This appendix gives an overview of these programming methods
Terminal Programming Through a Direct Connection
To program the system through a PC or terminal connected to the DBS 824 s
CN2 serial port
1 Make certain the cables are configured and connected as described in
2 Make certain the DBS 824 is in the Maintenance mode Dial the following
3 Enter your terminal communications program and make sure your PC or
4 From your terminal communications program (terminal emulation in a PC
5 After the DBS 824 displays the "Remote Programming" banner screen on
6 Follow the directions on the screen to access the desired program
Issued 3/l/95
Direct Connection
package to connect directly to the DBS 824 serial port
Dial into the system through a DISA trunk
Operator Transfer
have the operator enter the Remote Programming ID Code
Section 300~Installation
codes from the attendant port
ON/OFF ##!I3
terminal's data communications settings match those of the DBS 824
communications package), type the following command
the computer, type P then press ENTER
DBS 824-10-400
a
remote PC or terminal and sent to the system
Use a local PC or terminal and a communications
Dial into the system through a regular trunk, then
B-l