Panasonic DBS 824 Manual page 278

2. Trunk Programming (FF2)
Use the FF2 programming addresses in this chapter to set parameters for the
CO trunks of the DBS 824 system
Most of these FF2 addresses require a trunk number and/or extension port
entry The acceptable range of trunks/extension ports varies according to the
configuration of your DBS 824 system The basic 824 unit (no 208
Expansion Cards installed) supports 4 trunks and 8 extension ports With one
208 EXP Card, the system will support 6 trunks and 16 extensions With two
208 EXP Cards installed (possible only with a CPC M card), the 824 will
support 8 trunks and 24 extension ports
This chapter covers the following topics
Trunk Port Operation
Private Trunk Line
Automatic Pause for PBX Line
Dial Tone Detection
Outbound DTMF Signal Duration for Auto-Dialed
Digits
Unsupervised Trunk Conference
Inbound Ring Pattern
Trunk Disconnect Detection Timer
DISA Start Tie
Trunk Circuit Type
CO Busy Tone Detection
Issued 3/l/95
Topic
DBS 824-10-400
Page
2-3
2-4
I
I 2-6 I
I 2-7 I
2-9
2-10
2-11
2-12
2-13
2-14
2-15
2-16
2-18
2-19
2-l