Panasonic DBS 824 Manual page 265

Remote Programming and DISA Codes
Remote Programming ID Code
Address FFl 4## (0000-9999)#
Description
The Remote Programming ID Code allows you to enter the terminal
programming mode This programming mode is used to enter programming
commands from a remote PC or a local PC connected directly to the SMDR
port (CNl)
You can enter the remote programming mode through any of these three
methods
l
l
l
For more information on the terminal programming mode, see Appendix B
Programming
To set the remote programming ID code
To reset the ID code to the default (9999)
I s&ed 3/l /95
CPC-S and CPC-M, Version 1 0 and higher
By dialing into the system through a direct DISA trunk
By dialing into the system through a regular CO trunk, then requesting the
operator to enter the Remote Programming ID Code
By using a local PC and communications package to connect directly to
the DBS serial port
DBS 824-l O-400
Remote Programming ID Code
I
l-117