External (Una) Relay Control; Ring Patterns For Una Terminals (Ml, Cl, & Bl) - Panasonic DBS 824 Manual

Ring Patterns For UNA Terminals (Ml, Cl, & Bl)

External (UNA) Relay Control

Ring Patterns For UNA Terminals (Ml, Cl, & Bl)
Software Version
Address
Description
Use this address to set
Universal Night Answer (UNA) The UNA feature allows these calls to be
signalled over a loudspeaker or amplifier
This address actually controls the UNA relay terminals labeled "Ml", 'Cl"
and "B 1 ' (located on terminal block CN4) on the CPC-M card A bell or tone
device can be attached to these relay terminals to simulate incoming ring over
the loudspeaker or the CO can be used as the ringing sound source
This address does not apply to the CPC-S card, which is not equipped with
UNA relay terminals (However, a UNA device can be plugged into the
"EPA" phono-jack on the CPC card, use address FFl 2# l# 37# to tell the
system the type of device -- UNA or External Page -- plugged into "EPA" )
The ring pattern choices in this address are continuous (the terminal
contacts are continuously energized to receive CO ring) or 'intermittent
(1 second ON / 3 seconds OFF to simulate incom$g ring on the bell or tone
device installed)
Programming
Related Programming
CO Day Ring Assignments FF4 l# (25)# (l-8)++
CO Night 1 Ring Assignments FF4 2# (25)# (l-8)#
CO Night 2 Ring Assignments FF4 9# l# (25)# (1-8)#
CO Ring Cycle Detection Timer FFl 3# 13# (0-3)#
CPC-M Only (Version 1 0 and above)
the
l=Continuous (relay contacts are continuously energized)
DBS 824-l O-400
ring pattern for incoming trunk calls sent to
(1
second ON / 3 seconds
OFF)
issued 3/l /95