Remote Maintenance; Remote Programming Mode - Panasonic DBS 824 Manual

Hide thumbs Also See for DBS 824:

Table of Contents

System Features

Remote Maintenance

(CPC-S and CPC-M)

The DBS 824 can be programmed from a remote terminal or from a remote

PC by connecting via modems to the Maintenance port on the Serial Interface

Unit (SIU) The Remote Programming Mode may also be used locally by

directly connecting to the Maintenance Port

(CPC-S and CPC-M)

Remote Programming Mode uses a modem connected to a "dumb" terminal

or a PC terminal program to access a modem connected to the DBS 824

Maintenance serial port. Local programming bypasses the modems and

connects directly from the PC or terminal to the Maintenance serial port

When programming from a terminal connected to the RS-232C

(Maintenance) port either directly or via a modem, perform the following

issue Date 3/l/95

Make certain that any cables and modems are configured and connected

as outlined in Section 300

Enter your terminal communications program and make sure your PC's

data communications settings match those of the DBS 824

If connecting remotely using modems, dial up the DBS 824 Maintenance

port modem following the procedures for your terminal package Once

connected, if the Bus Monitor is active, Bus monitor information may

Set the DBS 824 to the terminal communications mode by entering or

have someone on site enter the following code at an extension or

attendant position

After the DBS 824 displays the DBS Remote Programming Banner

Screen, type P and then press Enter

DBS 824-l O-700

Remote Maintenance

Table of Contents