Setting Voice Mail (Vm) Tone Detection - Panasonic KX-TG5200C Operating Instructions Manual

TG5200CE.fm.fm Page 40 Tuesday, March 23, 2004 11:37 AM
Voice Mail Service
To erase a stored voice mail access number
Repeat steps 1 to 4 on page 39, then press and hold the soft key (
until all of the digits are erased. Press the soft key (
[OFF]
.

Setting Voice Mail (VM) Tone Detection

Your telephone company sends special signals (Voice mail tones) to the unit.
Press [ ] or [s] to listen to the dial tone. If you hear a series of dial tones followed
C
by a continuous dial tone, this indicates that a new message was recorded. Voice
Mail detection is preset at the factory to OFF. Minutes after you hang up or after the
phone stops ringing, your unit will check the phone line to see if a message has
been recorded. If a new message was recorded at your telephone company,
" "
will be displayed on the handset, the Ringer/Message Alert
Voice Mail
indicator on the handset will flash slowly if Message Alert is turned on (p. 19), and
the VM indicator will flash on the base unit.
Leave this feature off when:
— you do not subscribe to a voice mail service,
— your telephone company does not send a series of tones followed by a
continuous tone to indicate that you have new voice mail, or
— your phone is connected to a business or office telephone system (PBX).
See below to turn this setting on.
If you are not sure which setting is required, consult your local telephone company
or contact the Panasonic Customer Call Centre.
1
Press [MENU].
2
Scroll to "Initial setting" by pressing
[d] or [B], then press the soft key (
3
Press the soft key (
4
Scroll to "VM tone detect" by pressing
[d] or [B], then press the soft key (
5
Select "On" or "Off" by pressing [d] or [B].
6
Press the soft key (
40
SELECT
) at "Voice Mail".
SELECT
SELECT
), then press [OFF].
SAVE
CLEAR
), then press
SAVE
Handset
Initial setting
).
Voice Mail
VM tone detect
).
VM tone detect
:Off
)