Panasonic DBS 824 Manual page 222

Stop Bit Length (Maintenance Port)
Software Version
Address FFl 2# 9# 4-N (193)#
Description
This program sets the length of the stop-bit parameter for a-ansmitted data
over Maintenance serial port CN2
Programming
Checking Communications Parameter Be sure to properly set all
Notes
communication programming addresses when modifying any single address
value Communication parameters for Maintenance are set with addresses
l-74
CPCS
and CPC-M, Version 1 0 and higher
DBS 824-I O-400
bit
bits
---
Issued