Background Music/Music-On-Hold; Guidelines; Installation - Panasonic DBS 824 Manual

Hide thumbs Also See for DBS 824:
Table of Contents

Advertisement

Background Music/Music-On-Hold

Background Music/Music-On-Hold

Guidelines

l
l
l
l

Installation

1
2
3
5-8
All configurations may use a single external music source for both
background music (BGM) and music-on-hold (MOH) The music source
connects to CN6 on the CPC
With the CPC-M, separate external music sources may be used for BGM
and MOH The MOH source connects to CN8 and the BGM source
CN6
connects to
NOTE MFRU circuit card (VB-4243 1) is installed
If an FM radio is connected to the BGM connector on the CPC, install it at
least 16 5 ft (5m) away from the main cabinet If it is too close, the
receiver may not function properly
The maximum input impedance of both terminals is 10k ohms The
maximum signal level is -10 dB
If you're using a single external source for both BGM and MOH connect
the source to CN6 on the CPC as shown in Figure 5-9 If you're using
separate sources, connect the MOH source to CN8 and the BGM source
to CN6 on the CPC-M as shown in Figure 5-10
If using an internal music source, ensure that an MFRU circuit card is
installed
If using an internal music source, adjust the MOH volume using VRl
(also labeled MOH) on the MFRU Note VRl also adjusts DISA
inbound ringing volume for calls using the MFRU
The DBS 824 must also be programmed to select the appropriate music
source See the DBS 824 Programming Guide (Section 400)
information
DBS 824-l O-300
Telephones and Peripheral Equipment
for more
Issued 3/l /95

Advertisement

Table of Contents
loading

Table of Contents