Section 4 Web User Interface Programming
4.7.3.1 Dial Tone
Tone Frequencies
Description
Value Range
Default Value
Configuration File Reference
Tone Timings
Description
Value Range
Default Value
Configuration File Reference
4.7.3.2 Busy Tone
Tone Frequencies
Description
Value Range
Default Value
Configuration File Reference
98
Administrator Guide
Specifies the dual-tone frequencies, in hertz, of dial tones using 2 whole
numbers separated by a comma.
0, 200–2000 (0: No tone)
Note
•
If the value for this setting is "350,440", the unit will use a mixed
signal of a 350 Hz tone and a 440 Hz tone.
350,440
DIAL_TONE1_FRQ (Page 146)
Specifies the pattern, in milliseconds, of dial tones using up to 10 whole
numbers (off 1, on 1, off 2, on 2...) separated by commas.
0–16000 (0: Infinite time)
Note
•
The unit will not play the tone for the duration of the first value,
play it for the duration of the second value, stop it for the
duration of the third value, play it again for the duration of the
fourth value, and so on. The whole sequence will then repeat.
For example, if the value for this setting is "100,100,100,0", the
unit will not play the tone for 100 ms, play it for 100 ms, stop it
for 100 ms, and then play it continuously.
•
It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
60,0
DIAL_TONE1_TIMING (Page 146)
Specifies the dual-tone frequencies, in hertz, of busy tones using 2
whole numbers separated by a comma.
0, 200–2000 (0: No tone)
480,620
BUSY_TONE_FRQ (Page 148)
Document Version 2011-11