Clock Setting Function - Ducati SUPERBIKE 848 EVO Owner's Manual

Clock setting function

This function is used to set the clock time.
To set the clock, select the "TIME Set" page from the menu.
Holding switch (1, fig. 8) pressed in position B "▼" for 3
seconds in this menu page gives access to the setup mode.
On entering this mode, the message "AM" will flash; if you
press switch (1, fig. 8) in position B "▼" the message "PM"
flashes; if you press switch (1, fig. 8) in position B "▼" mode
will go back to previous setting (if it is 00:00, when toggling
from "AM" to "PM", 12:00 will be displayed).
Pressing switch (1, fig. 8) in position A "▲" gives access to
the hour setting mode; hours start to flash. Each time you
press the button in position B "▼", the digit will increase by
one hour. If the switch is held pressed in position B "▼" the
number increases cyclically in steps of one hour every
second (when the switch is held depressed, the hours do not
flash).
Pressing switch (1, fig. 8) in position A "▲" gives access to
the minutes setting mode; minutes start to flash. Each time
you press the button in position B "▼", the digit will increase
by one minute. If you hold the switch down in position B
"▼", the count increases cyclically in steps of 1 minute every
second. If the button is held depressed in position B "▼" for
over 5 seconds, minutes will increase by 1 minute every
100ms (while the button is held depressed in position B "▼",
seconds will not flash).
Pressing the button in position A "▲", exits setup mode and
the new time is displayed.
B = ON for 3 secs.
Flashing
B
Flashing
B
Flashing
B
Flashing
B
B
A
B
A
A
A
A
Flashing
A
Flashing
fig. 24
31
E