Clock Setting Function (Clock) - Ducati hipermotard 2016 Owner's Manual

Clock setting function (CLOCK)

This function allows setting the clock. To display the
function, enter the setting menu and access the
"CLOCK" page. To access the setting function, keep
button (4) pressed for 3 seconds. After 3 seconds, the
"SETTING...." indication will be activated to indicate
the access to the setting function.
On entering this mode, the message AM will flash;
- if you press button (2) the "PM" indication starts
flashing;
- if you press button (2) you will return to the
previous step (if time is 00:00, 12:00 will be
displayed when switching from "AM" to "PM").
Press button (4) to shift to hour setting, hours will
start flashing;
- each time button (2) is pressed, counter will
increase in steps of 1 hour;
- keep button (2) pressed to make counter
increase in steps of 1 hour per second (hours will
not flash while button is pressed).
Press button (4) to shift to minute setting, minutes
will start flashing;
- each time button (2) is pressed, counter will
increase in steps of 1 minute;
- keep button (2) pressed to make counter
increase in steps of 1 minute per second.
- If button (2) is kept depressed for more than 5
seconds, speed increases and digits change in
steps of 1 every 100 ms (when button (2) is held
depressed, seconds will not flash).
To confirm (store) the new set time press button (4).
"EXIT" will be automatically highlighted and by
pressing button (4) it will be possible to go back to the
setting menu.
Note
In the event of a Battery off, when power is
restored and upon the next Key-On, the time will have
to be set again (it will automatically start counting
from 00:00).
109