Clock Setting Function - Ducati Diavel ABS 2012 Owner's Manual

Clock setting function

This function sets the clock.
To access the function it is necessary to view the
"setting" menu page 48, using button (1, fig. 23)
"▲" or (2, fig. 23) "▼" select the "CLOCK" function
and press the reset button (12, fig. 21) to confirm.
In the following screen the message "SETTING" is
highlighted in green (3, fig. 66); now, press the reset
button (12, fig. 21) for 3 seconds to edit the time
displayed on the dashboard on handlebar and the
"SETTING" indication highlighting turns gray (4,
fig. 66).
Clock setting
On entering this mode, the message "AM" will flash;
if you press the button (2, fig. 23) "▼" "PM" flashes;
if you press the button (2, fig. 23) "▼" you will return
to the previous step (if it is 00:00, when switching
between "AM" to "PM", 12:00 will be displayed).
pressing button (1, fig. 23) "▲" accesses the hour
setting mode; the hours start to flash.
each time you press the button (2, fig. 23) "▼" the
digit will increase by 1 hour; if the button is held
pressed down (2, fig. 23) "▼" the digit will increase
by 1 hour every second (when the button is held
depressed, the hours do not flash).
pressing button (1, fig. 23) "▲", gives access to the
minute setting mode; minutes start to flash.
104
each time you press the button (2, fig. 23) "▼" the
digit will increase by 1 minute; holding down the
button (2, fig. 23) "▼" the digit will increase by 1
minute each second;
if the button is held down (2, fig. 23) "▼" for more
than 5 seconds the steps increase by 1 every 100 m
(during prolonged pressing of the button (2, fig. 23)
"▼" the seconds will not flash).
If you press button (1, fig. 23) "▲" setting is
completed and the dashboard on tank display
"SETTING" item is again highlighted in green (5,
fig. 66).
To exit, select "EXIT" and press the reset button (12,
fig. 21).
Note
In case of a battery cutoff, when the voltage is
restored and at the next Key-On, the clock is always
reset (it starts automatically from 00:00).