Clock setting function
This function sets the clock. To access the function it
is necessary to view the "setting" menu page 86;
using button (1) or (2) select the "CLOCK" function and
press the reset button (4) to confirm.
In the following screen the message "SETTING" is
highlighted in green (A); now, press the reset button
(4) for 3 seconds to edit the time displayed on the
instrument panel on handlebar and the "SETTING"
indication highlighting turns gray (B).
Clock setting
On entering this mode, the message "AM" will flash;
if you press the button (2) "PM" flashes; if you press
the button (2) you will return to the previous step (if
it is 00:00, when switching between "AM" to "PM",
12:00 will be displayed). Pressing button (1) gives
access to the hour setting mode; hours start to flash.
Each time you press button (2), the digit will increase
by 1 hour. If you hold button (2) down , the count
increases cyclically in steps of 1 hour every second
(during prolonged pressing of the button the hours
will not flash).
Pressing button (1) gives access to the minute setting
mode; minutes start to flash. Each time you press
button (2), the digit will increase by 1 minute. If you
118
hold button (2) down , the count increases cyclically
in steps of 1 minute every second.
if the button (2) is held down for more than 5 seconds
the steps increase by 1 every 100 m (during
prolonged pressing of the button (2) the seconds will
not flash).
If you press button (1) setting is completed and the
display of instrument panel on tank shows the
"SETTING" item again highlighted in green (C).
To exit, select "EXIT" and press the reset button (4).
Note
If the battery is cutoff, when the voltage is
restored and at the next Key-On, the clock must be
reset (it starts automatically from 00:00).