Example 2: Video Conference - Avaya IP500 V2 Installation Manual

8.11.2 Example 2: Video Conference

In this example, calls are routed to a Polycom Viewstation module connected to a S0 port of the IP Office system.
The following settings were used on 4 incoming data channels of a PRI line:
· Line Number: 5
· Channel Allocation: 23 -> 1
· Switch Type: 5ESS
· Line Sub Type: PRI
· Provider: AT&T
· Channels: 1-4
To route an incoming video call on the PRI lines configured above to an SO8 module requires the following:
1. Create a dial short code that has the SO port as its destination Line Group. For this example the following was used:
· Short Code: 1500
· Number: .
· Feature: Dial
· Line Group: 601 (the SO8 port number)
2. Create an Incoming Call Routing that routes the appropriate calls to that short code. For this example the following was
used:
· Line Group: 95 (identifies calls using the PRI lines configured above)
· Destination: 1500 (the short code created above)
· Bearer: Any
To allow the video device on the S0 port to make outgoing calls to the PRI lines also requires a short code.
1. For this example the following was used:
· Code: 91N;
· Number: N
· Feature: Dial
· Line Group: 95
Installing IP500/IP500 V2
IP Office 9.0
· Incoming Line Group: 95
· Outgoing Line Group: 95
· Direction: Bothway
· Bearer: Data
· Service: Accunet (this is a important)
· Admin: In Service
Additional Processes: So8 BRI Module
15-601042 Issue 28c (19 August 2013)
Page 175