Analog Phone - Avaya IP500 V2 Installation Manual

10.3.2 Analog Phone

This card is used to add analog phone ports to an IP500 and IP500 V2 control unit. It is available in two variants,
providing either 2 or 8 analog extension ports.
Port Type Ports
Analog 1 to 8
Extension
Optional Trunk 9 to 12
Card Ports
Name
IPO 500 Extn Card Phone 2
IPO 500 Extn Card Phone 8
Installing IP500/IP500 V2
IP Office 9.0
· Supports
Provides either 8 or 2
variant.
· IP500 Control Unit:
· IP500 V2 Control Unit:
· Maximum per Control Unit: 4.
· IP500 Trunk Card Support:
Features
· Supports ICLID modes DTMFA, DTMFC, DTMFD, FSK and UK20.
· REN 2 (1 for external bell device).
· Off-Hook current: 25mA
· Ring Voltage: 40V.
· Intended for connection to two-wire analog phones, the ports do not include a ringing
capacitor. For connection to 4-wire analog phones, connection should be via a master
socket with ringing capacitors.
· If fitted with an analog trunk card, for the Phone 8, during power failure extension port
8 is connected to the analog trunk port 12.
Port LEDs
· No status LEDs are used for analog phone extensions.
· LED1 is also used for base card status:
· Red On = Error
· Red Slow Flash = Initializing.
The card can be fitted with one trunk daughter card of any type. The trunk daughter card
then uses ports 9 to 12 on the base card for its trunk connections.
Port LEDs
LED use depends on the type of daughter card installed on the base card:
· LED 9 is also used for daughter card status.
· Red On = Error
· Red Slow Flash = Initializing.
Analog Card · Green on = V1: Card installed. V2: Line connected to the port
· Green flashing = Line in use.
PRI Card · Off = No trunk present.
· Green on = Trunk present.
· Green flashing = Trunk in use.
· Red/Green Fast Flash (port 9) or Green Fast Flash (port
· Red with Green Blink (port 9) or Green Blink (port 10) =
BRI Card · Off = No trunk present.
· Green on = Trunk present.
· Green flashing = Trunk in use.
Description
IP Office 500 Extension Card Phone 2
IP Office 500 Extension Card Phone 8
analog
390
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
· Red Flash every 5 seconds = Card okay.
· Red Fast Flash = System shutdown.
but idle.
10) = Alarm indication signal (AIS) from the trunk remote end.
Port in loopback mode (set through IP Office System Monitor).
System Components: IP500 Base Cards
phone ports depending on card
1.
SAP Code
700431778
700417231
15-601042 Issue 28c (19 August 2013)
Page 221