5. Initial Configuration Using Ip Office - Avaya IP500 V2 Installation Manual

5. Initial Configuration Using IP Office Manager
This section covers basic configuration changes required for IP Office systems if using the IP Office Manager application.
This covers just the basic configuration, the full range of configuration possible through IP Office Manager is covered in the
IP Office Manager manual.
1. Enter Licenses
103
Enter licenses for features that require them.
2. Set the System Locale
Setting the correct system locale affects a wide range of settings including trunk settings. The correct locale must
be set for a system to operate correctly.
3. Set the Extension Numbering
Renumber the user extensions if required.
4. Change the Default Passwords
The default passwords used for configuration access to the IP Office system should be changed.
Change the IP Address/DHCP Settings
5.
If necessary, the IP address and DHCP mode of the IP Office system can be changed.
6. Remove any Unused Trunks
Disabling the use of trunks and trunk channels that are not available.
7. Select the Clock Source for Digital Lines
Altering which digital trunk is used to provide the IP Office with its clock signal for call synchronization.
8. Enter Trunk Prefixes
On systems where a prefix is being used for external dialing, ensure that the same prefix is added to incoming
numbers in order to allow return calls.
9. DS16B/30B Port Mode Selection
These modules can support Avaya T-Series and M-Series phones by providing TCM ports or other Avaya digital
phones by providing DS ports. The port type selection for the whole module is done using IP Office Manager.
Installing IP500/IP500 V2
IP Office 9.0
104
108
106
105
110
112
114
115
15-601042 Issue 28c (19 August 2013)
Page 102