Ip400 Expansion Modules - Avaya IP500 V2 Installation Manual

10.9 IP400 Expansion Modules

The following IP400 external expansion modules are supported by IP Office Release 9.0 and can be used with an IP500
and IP500 V2 control units. Each module uses an external
specific power cord for the PSU must be ordered separately.
40
If being rack mounted these units use the IP400 rack mounting kit. If being rack mounted, these units use the IPO IP500
RACK MNTG KIT. They cannot be wall mounted.
IP400 Analog Trunk Module (ATM16)
·
Provides an additional 16
Supports both loop-start and ground-start trunks.
· Available in a number of variants for different locales.
· Use with ground start trunks requires that the trunk module and the IP
Office control unit are grounded.
IP400 Digital Station Module
·
Provides, depending on the variant, an additional 16 or 30
supported Avaya digital phones. This module has been superseded by the
Digital Station V2.
IP400 Digital Station Module V2
·
Provides, depending on variant, an additional 16 or 30
supported Avaya digital phones
module.
IP400 Phone Module
·
Provides, depending on variant, an additional 8, 16 or 30
analog phones. This module has been superseded by the Phone Module V2.
IP400 Phone Module V2
·
Provides, depending on variant, an additional 8, 16 or 30
analog phones. Supersedes the previous Phone module. With IP Office 3.1,
the Phone V2 supports a wider range of message waiting indication (MWI)
options than Phone V1 modules.
· With V2 units, the labeling of analog phone ports was changed from POT to
PHONE.
Installing IP500/IP500 V2
IP Office 9.0
266
ANALOG ports for connection of analog trunks.
390
270
268
. Supersedes the previous Digital Station
48
274
272
power supply unit supplied with the module. A locale
39
DS ports for
393
DS ports for
393
POT ports for
398
PHONE ports for
398
15-601042 Issue 28c (19 August 2013)
Page 264